Danfoss VLT FC Series Petunjuk Manual - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pengontrol Danfoss VLT FC Series. Danfoss VLT FC Series 11 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT FC Series: Panduan Instalasi (12 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (6 halaman)

4.0 Configure the PLC's I/O.

Previous to the following steps, the EDS file for the Danfoss FC drives has to be installed. Please see MG.90.Jx.yy for

detailed information.

Add the VLT FC to the EtherNet/IP scanner module. When the module is added, the following module dialog will appear

as in figure 5:

Figure 5

Insert the IP address used in Par. 12-01, e.g. 192.168.1.10.

(All IP addresses must unique for each device connected to the network).

Set the Name field to e.g. "FC302". This will be the Tag used for the actual communication between PLC and

drive. It is also the In- and Output tag for the Danfoss Add-On-Instruction.

Change the module connection instance from 100/150 to 103/153 by clicking on the button 'Change...' and the

Module Definition dialogue will appear, as in figure 6.

Figure 6

VLT

MCA 121 EtherNet/IP Add On Instruction

MI3xxxxxxx - VLT

is a registered Danfoss trademark