Danfoss VLT HVAC Drive FC 102 Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Danfoss VLT HVAC Drive FC 102. Danfoss VLT HVAC Drive FC 102 18 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT HVAC Drive FC 102: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Petunjuk Instalasi (12 halaman), Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Instalasi (6 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Buku Petunjuk (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (6 halaman)

Installation

3.8.3 Wiring Procedures

Wiring pocedure for enclosure types A1-A3

Mount the pre-configured cable wires with the

connectors on the fieldbus option. For A1 and A2

enclosures, mount the supplied strain relief on

top of the frequency converter with 2 screws, as

shown in Illustration 3.10. For cable specifications,

refer to chapter 3.8.2 Cable Specifications.

Position the cable between the spring loaded

metal clamps, to establish mechanical fixation

and electrical contact between cable and ground.

Eth erN et

Po rt1

OP CP RT

Eth erN et/

MS 1

MA C-0 0-1

MS 2

SW .ve r.

Illustration 3.10 Wiring for Enclosure Types A1-A3

MG90U402

Installation Guide

Eth erN et

Po rt2

Op tio n

B-0 8-0 0-0

0-2 2

Wiring procedure for enclosure types A4-A5, B1-B4, and

C1-C4

Push the cable through the cable glands.

Mount the pre-configured cable wires with the

connectors on the fieldbus option. For cable

specifications, refer to chapter 3.8.2 Cable Specifi-

cations.

Fix the cable to the metal base plate using the

springs, see Illustration 3.11.

Tighten the cable glands securely.

Illustration 3.11 Wiring for Enclosure Types A4-A5, B1-B4, and

C1-C4