Danfoss VLT HVAC Drive FC 102 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengontrol Danfoss VLT HVAC Drive FC 102. Danfoss VLT HVAC Drive FC 102 11 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT HVAC Drive FC 102: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Petunjuk Instalasi (12 halaman), Panduan Instalasi (18 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Instalasi (6 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Buku Petunjuk (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (6 halaman)

Installation Instructions

Mounting the Pressure Tubes

PTU 025 has 5 mm (0.2 in) tube connection taps. Attach high-pressure input tubes to the taps labeled H +, and the low-pressure

tubes on the L - taps. To prevent clogging of sensors, attach tubes to all connection taps. See Illustration 1.7.

Illustration 1.7 Mounting Pressure Tubes

NOTICE

Put a tube connection on all pressure transmitter taps to minimize the amount of dirt entering the unit. The minimum tube

length is 80 mm (3.1 in). If a sensor uses the surrounding pressure level, cut the tube at a place farther than the tube relief

plate.

Pressure Transmitter Unit PTU 025

VLT

HVAC Drive FC 102

MI08A102