AOG L series Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk panggangan AOG L series. AOG L series 2 halaman. Stand alone outdoor gas grill
Juga untuk AOG L series: Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman)
Halaman Cetak
Note: For infrared burner (IR) equipped
grills; see detailed instructions
included in your owner's manual.
Cooking Grid
Vaporizer panel
(not with IR)
Main burner
Warming
rack
Sideburner shelf
(if equipped)
Igniter
switch
Drip tray
heatshield
Drip tray
Fig. 4-1
Read setting
Read setting here
here
OFF
Fig. 5-1 - Burner valve control knob
WHEN OPERATING THIS
APPLIANCE WITH PROPANE,
ALL INSTRUCTIONS AND
WARNINGS MUST BE
OBSERVED. FAILURE TO DO
SO MAY RESULT IN A FIRE
OR EXPLOSION CAUSING
SERIOUS INJURY OR DEATH.
6-Propane Safety
Gas Cylinders
IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND IN
YOUR OWNER'S MANUAL.
REV 0 - 1602080910
IR cover
(if equipped)
IR burner
(if equipped)
Backburner
(if equipped)
Grill lights
(not shown)
Rotisserie kit
(if equipped)
Power
supply
Light
switch
5-Test
Note:
Grill must be connected to 120VAC power for electronic lighting.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO NOT turn on more than one valve at a time for either electronic or manual lighting.
HIGH to
High to
LIGHT
light
4.
Depress the control knob for the burner to be lit and turn it to the HI LIGHT position, then
press the ignition button. Once the burner lights, release the ignition button.
CAUTION:
If a burner does not light within fi ve (5) seconds of turning on the control knob,
depress the knob and turn it to the OFF position. WAIT FIVE (5) MINUTES before
repeating step 4. If you smell gas, follow the instructions on the cover of the grill
owner's manual. If the burners still do not light after several attempts, refer to the
grill owner's manual for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
Igniter
switch
Sideburner
control knob
(if equipped)
main burner
control knob
30
and 36
"
4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation in
Fig. 4-1:
Vaporizer panels, cooking grids, and warming rack.
Leave pre-installed burners in place to maintain proper alignment.
Vaporizer Panels
Place the vaporizer panels directly onto the studs on the burners. The
panels allow heat from the burners to be evenly directly throughout the
cooking area.
Cooking Grids
Place the cooking grids (over the burners) onto the grid frame.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner's manual to remove or replace.
Shelf/Sideburner (if equipped)
Align the four (4) holes in the shelf with the four (4) holes in the side of
the cart while aligning and engaging the burner venturi with the orifi ce
(Fig. 4-2). Insert the four (4) screws (provided) into the holes and tighten.
Make the igniter wire connection as shown in Fig. 4-2. Open sideburner
lid, set cap on burner, and set grid into shelf.
IMPORTANT: See your grill owner's manual for complete
installation details.
The burner ports and
carry-over ports must
be kept clean to ensure
proper ignition and
operation.
Replacement parts can
be ordered from your
local AOG dealer.
Center main burner
control knob
Left
Drip
tray
model controls
"
Connect
Igniter wire
Screws
Air shutter
Venturi
Fig. 4-2
Right
main burner
control knob
Backburner
control knob
(if equipped)
Control panel
screw(s)
Light switch
Fig. 5-2
Orifi ce
L-C2-482