Dunavox DAB-89.215DB Buku Petunjuk - Halaman 8
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pendingin Anggur Dunavox DAB-89.215DB. Dunavox DAB-89.215DB 20 halaman.
Juga untuk Dunavox DAB-89.215DB: Buku Petunjuk (16 halaman)
guarantee the required safety of the appliance (e.g.
danger of overheating).
The appliance must not be connected to an inverter
and must not be used with a plug adapter as these
can cause damage to the appliance's electronic unit.
The cord must rest securely behind the appliance
and not be allowed to lie or hang unprotected.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
INSTALLING THE HANDLE
IMPORTANT: Do not overtighten the screws & do
not use power tools to install the handle.
DESIGN 1 –
1
2
○
Locate the handle
,1 over the fixing pins
the door and using the supplied allen key, tighten
the securing grub screws
DESIGN 2 –
1
2
3
1.
Remove the door gasket
wish to install the handle - you can see two
designated holes for handle installation.
○
2.
Install the handle
○
with two screws
provided.
3.
Replace the door gasket.
Code Rev. D 20140818 (IEC)
3
○
,3 of
○
,2 to fix the handle.
4
5
○
on the side you
,1
tightly as shown above
,4
○
and flat washers
,3
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
Note: All parts removed must be saved to
do the reinstallation of door.
DESIGN 1 – For built-under models
1.
Remove the ventilation grille
adjustable ventilation grille
the screws
NOTE: For some models without adjustable
ventilation grille, the step is not needed.
2.
Remove the bottom hinge
the four lock screws
the glass door firmly after removing the screws.
(Fig. 2)
3.
Gently pull down to remove the glass door
from the right top hinge and place it on a
padded surface to avoid the risk of damage.
Then remove the right top hinge
4.
Unscrew and transfer hinge pin
door stopper
opposite side. (Fig. 3)
5.
Pop out the cover caps on the left side of
cabinet and use them to
on the right hand side.
6.
Screw the alternative left top hinge
included in the fittings,
cabinet. (Fig. 4)
7.
Unscrew and transfer the holes cover
,2
and lock catch
glass door. (Only for models with lock on the
ventilation grille) (Fig. 5)
Rotate the door 180° (No need for models with
8.
8
○
○
by unscrewing
,1
○
○
. (Fig. 1)
,3 &
,4
○
,5 by unscrewing
○
,6. Be careful to hold
○
○
○
,8of the bottom hinge to the
cover the screw holes
on the left hand side of
○
,13 to the opposite side of
and the
,2
,9. (Fig. 4)
,7 and/or
○
,11 ,
○
,12