AOM 3A MIX Panduan Penggunaan dan Perawatan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Penyemprot Cat AOM 3A MIX. AOM 3A MIX 17 halaman.

USE AND MAINTENANCE MANUAL

3.1 INSPECTION OF PURCHASED PRODUCT

Inspect the equipment before its use to check for damages caused by transportation or

improper storage. Make also sure that all standard and optional components have been

delivered.

The gun must be fed with a maximum fluid pressure of 140 bar (2000 psi).

It is advisable to use dry compressed air to obtain the best painting results.

To mount the double hose (air/product) proceed as follows (use the drawing below):

Fasten the air inlet hose (BLUE hose) to the gun buckle (A).

Fasten the paint inlet hose (LIGHT BLUE hose) to the gun buckle (B).

Choose which nozzles and spray gun filter better adapt to the operation which must be

performed.

WARNING

On one side of the pump cart (K15) there is a unit formed by two filters with pressure regulators.

Finding the M1/4" air outlet connector (which

must be connected to the gun air buckle "A") is

fairly simple since there are only two connectors

for the air connection; the other one is the pump

air inlet.

WARNING

Always use high pressure hoses to carry out all

connections. Before using the equipment, make sure

the connections and hoses are in perfect working

conditions, that is without holes, bends or splits.

Regulate the spraying angle (fan) by the

wheel (1) (by opening the wheel, you will open

the spraying angle).

Regulate spraying fan position by turning the

cap (3), see drawing below.

Gradually open the fluid passage by turning

the wheel (2) until the desired quantity is

obtained. Check the regulation on a smooth

trial surface until reaching the desired fan.

(3)

(B)

FAN POSITION

(1)

(2)

(4)

(A)

Page 10 of 14