Duncan SFX-10 Deja Vu Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pedal Musik Duncan SFX-10 Deja Vu. Duncan SFX-10 Deja Vu 17 halaman. Tap delay w/bbd

Playing with the Wet Out/Loop

By now you've figured out that the SFX-10 Tap Delay w/BBD can do clas-

sic delay beautifully. But it can do more—a lot more. The key to many of

the SFX-10's most unique effects lies in the Wet Out/Loop jack. So what

does this jack do anyway? We're glad you asked . . .

The Wet Out/Loop

The jack uses a TRS (tip/ring/sleeve) jack as an insert point in the delay

tone. The tip is the wet send, and the ring is the return. When used

with a mono cable, it turns this jack into a wet out, and takes the wet

signal away from the main outputs. The L/R jacks now become dry only.

But, when used with an "insert cable" (one TRS to two mono jacks) it

becomes an effects loop for the delayed signal only. Let's examine what

happens with the following processors in the Wet Loop:

Volume Pedal:

If you put a volume pedal in that loop, it now becomes a volume con-

trol on your delays. You can set the Mix knob for the desired amount

of maximum Wet/Dry blend, and the volume pedal will fade the delays

from maximum to off.

Distortion/Overdrive:

Distortion and Overdrive need a healthy signal to make the distortion.

That's why loud pickups produce more distortion in your pedals than

quiet ones. In a delay loop, each delay is quieter than the last. So adding

distortion to your delayed sound will produce less recycled distortion

with each repeat, but the delay will be repeating the previously distorted

sound. It's a good way to add dirtiness to your delays while keeping

your dry signal crisp.

Chorus/Flange/Phaser:

Since these effects are not dependent on volume, each of these modu-

lation effects will become more intense with each repeat, because the

effect on the sound is compounded.