Duncan Tweak Fuzz Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pedal Musik Duncan Tweak Fuzz. Duncan Tweak Fuzz 6 halaman. Seymour duncan tweak fuzz pedal user manual

Halaman Cetak

Battery

To make your Tweak Fuzz work, you'll need to insure that a fresh battery

is installed. If not, you'll need to install one, or connect a regulated 9V DC

power supply – see below for details.

To replace the battery, simply:

a Make sure your Tweak Fuzz is not connected to a DC Power Supply

(see below).

b Remove the four screws on the underside of the box and disassemble

the chassis.

c Remove the old battery from the clip, if applicable.

d Install a fresh 9 volt alkaline battery, taking care to properly orient the "+"

and "-" terminals (see Figure 1 for proper battery orientation).

e Reassemble the chassis and replace the screws.

When storing the Tweak Fuzz, or when it is not in use, make sure no cable

or plug is inserted into the "Input" jack, as this will shorten battery life. As

an alternative to a battery, you can use a regulated DC power supply ("wall

wart") ranging from 9 – 12 volts, for example a Boss

# PSA-120T or DOD

#PS200R. These are available at electronics supply stores and most music

stores.

Figure 1