Installation Guide | VLT® Wireless Communication Panel LCP 103
Procedure
1. Open the app and establish the Wi-Fi connection, see
2. When prompted, change the default password due to security restrictions. The password must be at least 8 and maximum 48
characters.
3. Replug the VLT® Wireless Communication Panel LCP 103 for the password to take effect. Failing to do so, allows the LCP 103 to
keep broadcasting.
4. Disconnect the app, navigate to smart device settings, and forget the network.
5. Search for the wireless network and connect with the new password.
If the password is not changed, it leaves only 10 minutes for connecting and performing drive operations. After this, the
wireless connection closes.
If the wireless SSID and password are forgotten, reset the password by accessing parameter group 30-9* Wifi LCP via MCT 10 Set-up
Software or LCP 102.
2.3 LED Pattern
Table 1: Descriptions, LED Indicators
LED
Pattern
On
Solid green
Wi-Fi
Flashing white
Solid white
Alarm
Flashing red
Warn
Solid yellow
Flashing orange
MS, NS1, NS2
(1)
Flashing, then solid orange
1
MS=module status, NS1=network status, NS2=network status 2.
2.4 Safe Control
The safe control parameter allows the drive to decide the motor behavior if the smart device, for example a tablet, communication is
lost. If the limits are set to [1] Stop motor, the motor stops. If the limits are set to [0] Do nothing, the motor continues to run. This is only
applicable when the motor is in Run state and if the motor has been started from the app.
The communication happens between the MyDrive® Connect App and the VLT® Wireless Communication LCP 103.
Parameter
Parameter 30-97 Wifi Timeout Action
Danfoss A/S © 2020.02
table 1
for descriptions of the white Wi-Fi LED.
N O T I C E
Description
The drive is powered on (normal operation).
Connection pairing successful.
The smart device is connected and communication is OK.
An alarm has occurred.
A warning has occurred.
Identification of the drive when initiated through a winking command
Incompatible drive (LED flashes 3 times and then remains on).
Limits/options
[0] Do nothing
[1] Stop motor
AN331428064824en-000101 / 130R0814 | 7
Installation
Halaman Cetak