Danfoss VLT AutomationDrive FC 302 Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Penggerak DC Danfoss VLT AutomationDrive FC 302. Danfoss VLT AutomationDrive FC 302 10 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT AutomationDrive FC 302: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Petunjuk Instalasi (4 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Petunjuk Instalasi (12 halaman), Panduan Instalasi (18 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (6 halaman)

Installation Instructions

1.4.2 Removing the IGBT Output Busbars

To remove the IGBT output busbars, use the following procedure. Refer to Illustration 1.4.

Remove 3 retaining screws (M10), 1 from the lower end of each of the 3 IGBT output busbars.

Remove 3 retaining nuts (M10), 1 from the upper end of each of the 3 IGBT output busbars.

Lift the 3 busbars from the unit.

IGBT output busbar

Fan housing

Current sensor

Illustration 1.4 IGBT Output Busbars

MI92Q102

500 A Current Sensor Kit for

E1/E2 Enclosure Sizes

VLT

FC 102, FC 103, FC 202, FC 302

Upper retaining nut (M10)

Lower retaining screw (M10)

Output terminal