Cashmaster OMEGA C Series 1000 Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penghitung Uang Tunai & Penyortir Koin Cashmaster OMEGA C Series 1000. Cashmaster OMEGA C Series 1000 12 halaman. Coin and note counting machine

Halaman Cetak
12. Counting bills
Ensure that the display indicates bill counting mode. If it doesn't, press bill < > or
bill < > to select loose bill mode.
57.19
Total
Auto
$1
Auto add on
Denomination
If the denomination is not the one you want, press bill < > or < > until you reach
the correct one.
Place bills of the selected denomination on the cash tray; the Omega "C" will beep
and the display will show the value of the bills currently on the tray:
74.19
Auto
$1
Bills should be applied in quantities of approximately 20 to 25 at a time. If too many
are applied the display will show:
TOO MANY BILLS
REMOVE SOME
Simply remove a few bills until the message disappears, then continue adding bills to
those already on the tray.
When all bills of the current denomination have been applied and:
Auto Add is off, leave the bills on the tray and press <+> to add to the total; remove
the bills from the tray then press bill < > to move to the next denomination.
Auto Add is on, remove the bills from the tray. The Omega "C" will update the totals,
beep to confirm the add, advance to the next denomination in the sequence.
Repeat above steps for each denomination of bill. To skip a denomination, press the
bill < > or < >.
Page 16
$0
Loose bill mode
(0)
$17
Value
(17)
No. of bills

6. Initial programming of bills

All Omega "C"s are calibrated in the factory but we recommend that, when you first
receive your machine, you complete the following process to ensure that any "local"
adjustments required are taken care of at the start.
1.
Press bill < > or < > until you reach the bill denomination required.
2.
Place 8-10 bills of the chosen denomination on the cash tray.
3.
When the Omega "C" beeps and the display is updated, add some more bills.
4.
Remove all bills from the cash tray.
5.
Repeat steps 2 - 4 several times and each time try to increase the number you
can apply in one slice.
If the display shows:
TOO MANY BILLS
REMOVE SOME
Remove a few until you see a valid reading, then continue.
6.
Eventually you should be able to apply up to 25 bills in one go.
7.
Repeat from step 1 until all bill denominations have been programmed.
N.B. This initial programming of loose bills must be completed for all bill
denominations before strapped bills can be verified.
Page 9