Danfoss VLT CDS 302 Panduan Pemecahan Masalah - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah untuk Penggerak DC Danfoss VLT CDS 302. Danfoss VLT CDS 302 18 halaman. Compressor drives
Halaman Cetak
Check List
Stop (figure 9)
Figure 9: Check pressure
switch
Run OK: 25Hz
Quick tip:
10
FRCC.PC.036.A2.02
Trouble shooting
Message displayed when the Terminal 27 is low
(no signal).
The RUN OK status display indicates that a run
command has been given to the drive but the
reference (speed command) is zero or missing.
Improperly connected wiring or interrupted
wiring is a common service issue for a motor
Ensure that terminal 27 is logic 1 (pressure
switch).
Check the control wiring to ensure that a
proper reference signal is present at the drive
input terminals and that the unit is properly
programmed to accept the signal provided.
not operating or the drive not responding to a
remote input.