Dune HD Duo 4K Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemutar Media Dune HD Duo 4K. Dune HD Duo 4K 16 halaman. Uhd 4k and hevc enabled iptv/vod/ott media player
Halaman CetakDUNE HD DUO 4K
9
Installation
Ensure there is enough space around the player for proper cooling. The space at
each side should be not less than 10 cm. When installing the player in an enclosed
cabinet, please ensure proper airflow and cooling inside the cabinet.
When installing the player in a hidden location, such as enclosed cabinet, you can
use the IR extender cable to allow the infrared signal from the remote control to reach
the player.
Getting Started
Ensure the RC has batteries installed.
Connect the player to your TV and to other A/V equipment in an appropriate way. Use
HDMI connection to get the best possible quality of video and audio. Make sure to
switch off the player and all relevant A/V equipment before connecting them. Ensure
your TV and other A/V equipment are configured to use proper inputs. Connect the
power cord to the player and switch the player on using the power switch on the back
panel of the player.
The player will perform its initial loading procedure, which may take up to about 1
minute. During the loading procedure, "DUNE HD" logo is shown on the TV screen.
If you do not see "DUNE HD" logo on the TV screen when you switch on the player, it
may mean some problem with the connection between the player and the TV or that
a wrong video input is chosen in the TV or A/V receiver/switch. In this case, recheck
the cables and the settings of the TV or A/V receiver/switch, or try to use different
cables or a different way of connecting the player to the TV.
If you see "DUNE HD" logo on the TV screen when you switch on the player, but then
the picture disappears and the other picture does not appear during at least 10
seconds, it may mean that a wrong video output mode is configured in the player. In
this case, press the "MODE" RC button, and then press one of the RC buttons "1",
"2", "3", "4" or "5" to switch to a different video output mode (see "Quick Setting of
Video Output Mode" for more information).
Finally, you should see the initial setup wizard, which will allow you to perform the
initial player configuration. After that you should see the main screen of the player
menu. The main screen shows menu items which allow the use of different player
functions and access to all storage devices and network drives connected to the
player.