Danfoss ECL Comfort 296 Panduan Servis - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Servis untuk Termostat Danfoss ECL Comfort 296. Danfoss ECL Comfort 296 16 halaman. Return temperature limitation
Juga untuk Danfoss ECL Comfort 296: Panduan Pengguna (12 halaman), Panduan Instalasi (20 halaman), Panduan Pengoperasian (8 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (10 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (16 halaman), Panduan Pengoperasian (8 halaman)

Service guide

7.2 Repeater stations (individual houses with repeater)

1) = surge protector

Note:

Normally repeaters' inputs and outputs are isolated. Check the

resistance between input common reference signal (S.Gnd1) and

output common reference signal (S.Gnd2) using multimeter.

If signals are having >1 Mohm, then connect the output side com-

mon reference signal to earth.

Internal termination of repeaters can be switched ON if the con-

nection matches with section 5 point 4.a

Internal termination of repeaters is switched OFF if the connec-

tion matches with section 5 point 4.b

8 | © Danfoss| 2017.06

ECL 296 / ECL 310 Modbus

2) = repeater

Input cable (coming from central heating station) shield MUST be

floating and output cable shield is connected to earth.

This is to maintain single point earthing in each network, on com-

mon reference signal (S.Gnd) and shield cable (Refer section 5 point

5, 6).

Dot on the intersection lines (S.Gnd, Earth) means that those two

signals are electrically shorted.

1) = surge protector

2) = repeater

3) = line termination (LT)

VI.LV.H1.02