Danfoss TP7000M Petunjuk Instalasi Petunjuk Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Instalasi Petunjuk Pengguna untuk Termostat Danfoss TP7000M. Danfoss TP7000M 14 halaman. Electronic programmable room thermostat
Juga untuk Danfoss TP7000M: Panduan Petunjuk Instalasi (9 halaman)
Halaman Cetak
- 1. Installation Instructions
- 2. Specification
- 3. Installation
- 4. DIL Switch Settings
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. Before You Start
- 8. Display Preferences
- 9. Setting the Clock & Day
- 10. Setting the OSC Period
- 11. Accepting the Preset Programmes
- 12. Before You Change the Preset Programmes
- 13. Programming in 7-Day Mode
- 14. To Convert to Thermostat Mode
- 15. To Programme Holiday Mode
- 16. User Overrides
Display preferences
Temperature display (°C or °F)
Press and hold DAY & COPY (for 2-3
seconds) until display changes.
Clock display (12 or 24 hr)
Press and hold NEXT & DAY (for 2-3
seconds) until display changes
(AM or PM will appear in 12 hr mode)
Setting the Clock & Day
Press PROG to begin programming
DAY - Press DAY until correct day is
shown (1=Monday, 2=Tuesday etc)
To change TIME
TIME - Press + and - to change time
To
(press and hold to change in 10 min
change
increments)
DAY
Setting the OSC Period,
if enabled (see pg.5)
This display will ONLY appear if the OSC
function has been enabled by your installer.
Use the + or - buttons to select the
OSC period. The choices are 0:30 (30
mins), 1:00 (1 hr), 1:30 and 2:00.
The recommended setting is 0:30. If set
to 0:00 the function is disabled.
Accepting the preset programmes
If you are happy to use the preset programmes on page 7,
you don't need to do anything else. To accept these settings
just close the front cover and after 2 minutes the pre-settings
will automatically be accepted.
8