Danfoss DHP-A Instruksi Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Instruksi Instalasi untuk Unit Kontrol Danfoss DHP-A. Danfoss DHP-A 6 halaman. Outdoor unit
Juga untuk Danfoss DHP-A: Panduan Petunjuk Instalasi (15 halaman)

Halaman Cetak

Installing the outdoor unit

It is essential that the outdoor unit is installed by two people.

1 .1

Check the delivery

The outdoor unit is delivered as three items:

• the outdoor unit, on a wooden pallet

• a box containing the stand, adjustable feet and all the necessary screws

• a box containing covers

The following tools are required for assembly and installation:

• Wrench, or equivalent, 10 mm

• Wrench, or equivalent, 13 mm

• Screwdriver, or equivalent, torx TX25

• Cross head screwdriver

• Drill bit Ø 3 mm

• Milling cutter Ø 6 mm, or equivalent

• Drill

Check that the following screws have been supplied:

• 8 x M6x10, hex screw

• 4 x M6x10, hex screw

• 5 x M6x15, torx TX25

• 2 x panel screws, crosshead

1 .2

Assembling the stand

1. Screw the two horizontal struts together (1) using the two ends (2) as illustrated below. Use 8 x M6x10 screws. The bent

edges of the horizontal struts must be facing upwards and inwards.

Slit

2. Screw the adjustable feet (3) into the holes under the ends.

1 .3

Preparing the outdoor unit

While the outdoor section remains on the pallet it should be prepared for placing on the stand. Carry out the following:

3. There are three M6x20 screws on the lower edge of the outdoor unit. Unscrew them so that 2-3 mm of the thread

remains. Use a torx TX25 screwdriver, or equivalent.

4. Raise the outdoor unit. NOTE! Do not lift the side plates.

5. Remove the side plates. They are held in place by clamps and so are removed by pulling outwards.

6. Remove all four screwed lifting eyes. Use a 13 mm wrench, or equivalent.

Bent edge

Figure 1: Assembling the stand .

VMBMF302

Slit