3W 200i B2 TS Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Mesin 3W 200i B2 TS. 3W 200i B2 TS 18 halaman.

3W 200i B2 TS Manual
Check your wheels for possible damage and easy running
Check the wing mounting for tight fit and proper attachment
Check the canopy for tight fit and proper attachment
When starting the engine one person (minimum) has to hold the model

Starting Procedure

If you have read and understood this entire manual, and followed its recommendations, you are
ready to start your new engine.
Use a rubber stick to start the engine. Never use your hand or fingers!
Insure that your receiver batteries are charged and your receiver is on
Insure that your ignition battery(s) are charged
Insure that your transmitter is on, and that your throttle is set to low
Insure that your plane is properly and safely anchored (use one, two, or more people if
necessary)
Close the choke(s)
Switch on the ignition
Flip the propeller until the engine "pops" (starts and stops quickly)
Wait for the propeller to stop spinning, turn off the ignition, and open the choke(s)
Switch the ignition back on
Flip the propeller again until the engine starts
Warm-up the engine for at least 20 seconds
Due to the high power and torque of the engine(s) it is not recommended to open the throttle
abruptly
Precision tuning of the carburetor
The use of a tachometer is highly recommended. And, again, never adjust the needles while the
engine is running!
1. Using the tachometer tune the engine for maximum power with the high needle (H).
2. Again using the tachometer; richen the high needle (H) until the motor runs 100-200 RPM
less than the maximum RPM. Now you are tuned slightly rich on the high needle (H).
3. Let the engine run at idle for one minute. Check to see that the idle RPM remains constant.
4. If the idle RPM drops until the engine stops; the low needle (L) is too rich. Lean the low
needle (L) until a constant idle RPM is achieved.
3W 200i B2 TS Engine Manual
more infos: www.3w-modellmotoren.de