Danfoss iC7 Series Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Konverter Media Danfoss iC7 Series. Danfoss iC7 Series 14 halaman. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Juga untuk Danfoss iC7 Series: Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (10 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman)

In-bottom/Out-top Cooling Kit for FA11-FA12

Installation Guide

Illustration 5: Dimensions of Vent in Top of Frequency Converter

48 (1.9)

159 (6.2)

3 (0.1)

6X 6 (0.2)

Illustration 6: Dimensions for Opening in Cabinet Top Plate

2.5 Assembling the Ducts

The top and bottom ducts are telescopic ducts that collapse to simplify installation. To assemble the ducts before installation, use

the following steps. Refer to

Procedure

Cut the strip of ribbed EPDM rubber seal into 4 pieces. Cut 2 strips of 1027 mm (40.4 in) for the top duct, and 2 strips of 990

mm (39.0 in) for the bottom duct.

Peel the paper off the self-adhesive seals. Place 1 strip on the outside bottom edge of the inner sleeve of each duct, and 1

strip on the upper inside edge of the outer sleeve of each duct.

378 (14.9)

160 (6.3)

0.0

Illustration

81 (3.2)

131 (5.2)

62 (2.4)

131 (5.2)

Installation

AN361429548582en-000201 / 136R0255 | 7