Danfoss VLT AQUA Drive FC 202 Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Konverter Media Danfoss VLT AQUA Drive FC 202. Danfoss VLT AQUA Drive FC 202 10 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT AQUA Drive FC 202: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (18 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Instalasi (6 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (6 halaman)

Installation Instructions

1.4.4 Removing the Current Sensor Wire Harness

Remove the current sensor wire harness using the following procedure. Refer to Illustration 1.6.

Disconnect the following items from the power card:

Unplug the 16-pin cable from the MK102 connector.

Detach the heat sink cable from its 3-pin connector.

Remove the screw (M5) attaching the ring terminal ground.

Detach the opposite end of the heat sink cable.

Detach the cable from the 3-pin connector on the high-frequency card.

Disconnect the wires from each of the 3 current sensors.

Detach any cable ties that secure the wire harness in the unit.

Remove the current sensor wire harness from the unit.

Power card

16-pin cable connector (MK102)

Illustration 1.6 Power Card

MI92Q102

500 A Current Sensor Kit for

E1/E2 Enclosure Sizes

VLT

FC 102, FC 103, FC 202, FC 302

Heat sink cable 3-pin connector

Ring terminal ground (M5)