Danfoss VLT AQUA Drive FC 202 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Konverter Media Danfoss VLT AQUA Drive FC 202. Danfoss VLT AQUA Drive FC 202 8 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT AQUA Drive FC 202: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (18 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Instalasi (6 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (6 halaman)

Halaman Cetak
Danfoss VLT AQUA Drive FC 202 Panduan Instalasi
IGBT Module Replacement for Fx09-Fx12 and E1h–E4h
Installation Guide
3.
Place the IGBT module on the heat sink by aligning the mounting holes in the module to those in the heat sink. Refer to
Illustration
2.
1
2
Illustration 2: Mounting the IGBT Module on the Heat Sink
1
IGBT module fastener
2
IGBT modules
4.
Insert the mounting screws and hand tighten them.
The IGBT module requires either 4 or 10 screws to fasten it to the heat sink.
5.
Following the fastener tightening sequence shown in
the torque values listed in
6.
Repeat the same tightening sequence and slowly tighten (maximum 5 RPM) all screws to 100% of the torque value.
Danfoss A/S © 2022.03
Illustration
Table 7
and
Table
8.
3
Brake IGBT modules
4
Plastic IGBT mounting frame
3, slowly tighten (maximum 20 RPM) all screws to 50% of
AN361427984575en-000101 / 130R0770 | 5
Installation
3
4