DUO-FAST DF150-CS Manual dan Skema Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Manual dan Skema Pengoperasian untuk Alat Listrik DUO-FAST DF150-CS. DUO-FAST DF150-CS 16 halaman. Cap stapler

Halaman Cetak

TOOL INSTALLATION

Your

tool comes ready for immediate use

Duo-Fast

and can be installed by following these steps:

1. SAFETY - All tool operators and their immediate

supervisors must become familiar with the operator

safety instructions before operating the tool. The

instructions are on page 4 of this manual.

2. Included with each tool is a copy of this

manual and tool schematic.

Keep this publication for future reference. An

o ownership registration card is also included.

This card must be completed and returned to

immediately to register your ownership.

Duo-Fast

3. The tool is shipped with a 1/4" male air fitting.

If you replace the air fitting, use only a male

pneumatic type that discharges the air from the

tool when the air line is disconnected.

4. Install a ﬁlter/regulator/lubricator unit, with a

gauge as close as practical to the tool, preferably

within ten feet. Refer to the Air Systems section of

this manual for air hose requirements and lengths.

In general, no other special installation is required.

5. If the operator is working at a bench or table,

it is usually best to run the air line underneath the

bench. A small tray under the benchtop can hold

the fastener supply and the tool when not in use.

6. If this tool does not work when it is ﬁrst connect-

ed, do not try to make repairs. Call your

representative immediately.

Pneumatic System Maintenance

- Be certain that:

• Pneumatic ﬁttings are tight and do not leak.

and ensure that automatic draining systems are

operating correctly.

• Air lines are cleared to prevent freezing,

especially in winter.

• Lubricator operation is checked regularly and

ensure it has an adequate supply of lubricant.

( Part No. 403720).

• Only regulated air is being used and that each

regulator is operating properly.

Tool Lubrication

It is most important that the tool be properly

lubricated by keeping the air line lubricator filled

and correctly adjusted. Without proper lubrica-

tion the tool will not work properly and parts will

wear prematurely.

Use the proper lubricant in the air line lubricator.

The lubricator should be of low air flow or

changing air flow type, and should be kept filled

to the correct level.

Use only

Substitutes may harm the rubber compounds in

the tools O-rings and other rubber parts. Part No.

403720 is a pneumatic lubricating oil specially

made for pneumatic applications.

Duo-Fast

If a filter/regulator/ lubricator is not installed on

the air system, air operated tools should be

lubricated at least once a day with 6-12 drops of

oil, depending on the work environment, directly

through the male fitting in the tool housing.

recommended lubricants.

Duo-Fast