Duo-Therm 57912.531 Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Pendingin Udara Duo-Therm 57912.531. Duo-Therm 57912.531 17 halaman. Roof top air conditioner/heat pump
Juga untuk Duo-Therm 57912.531: Panduan Petunjuk Instalasi (17 halaman)
Halaman Cetak
11. INSTALLATION OF INSIDE DECORATIVE COVER.
Installing unit with 3105007.XXX or 3105935.XXX
Return Air Cover.
A. Locate the relay control box on the ceiling template
with the white 6 connector plug on the right (curb side)
side of RV.
B. Drive two #10 x 3/8" blunt point Phillips head screws
through the ceiling template into holes in control box to
hold it in place.
C. Remove the return air grill from the return air cover.
D. Place the return air cover up to the ceiling template.
E. Install cover to template with #8 x 3/8" blunt point Phil-
lips head screws provided (6 required).
F. Reinstall filter return air grill into return air cover. Align
tabs with mating notches and snap into place
G. Install two hole plugs into screw holes in back of return
air cover. See FIG. 16A.
FIG. 16A
Hole
Plugs
This completes the installation of the air conditioner.
We recommend that power be supplied to the air condi-
tioner/heat pump and check for proper operation. Refer
to Operating Manual or Users Guide for a description of
the air conditioner/heat pump operation.
Installing unit with 3308120.XXX Genesis Air Filtra-
tion System.
A. Install the slider in the return air cover and raise it to
Return Air
Cover
B. Insert the filter from the right side (looking toward the
Return
Air Grill
C. Place grill on return air cover and snap in place. Decal
D. Place slide handle through slots in grill into the slide
15
INSTALLATION INSTRUCTIONS DUCTED BI-METAL
the ceiling template. Route the wires from the return air
cover through the template slot leaving about 3" be-
tween, and position wire here they can be reach after
plastic cover is installed. See FIG. 14B. Place the front
of the return air cover against the ceiling and slide to-
wards the rear. The flange on the ceiling template will
catch in the groove on the return cover. Adjust the posi-
tion (right to left) and install the front two screws. In-
stall the remaining screws.
Note: Number 10 cabinet screw can be used to re-
place the two front screws to hold the plastic cover
flush to the ceiling.
1.
Connect together the wires from the 12VDC power
supply and filter indicator.
a. Connect the red wire from the (+12VDC) power
supply and the red wire from the filter indica-
tor light with the red. See figure 13B.
b. Connect the black (-12VDC) power supply and
the black wire from the filter indicator light.
If solar panel is installed see instruc-
Note:
tions packaged with solar panel option.
RV front) over the wires. Make sure the wires are se-
cured above the filter and will stay out of its way.
is on end over circuit board.
FIG. 16B
Foam
Divider
Slider
Return Air
Cover
Handle
posts. Handle will fit in either direction.
This completes the installation of the air conditioner/
heat pump. We recommend that power be supplied to
the air conditioner/heat pump and check for proper op-
eration. Refer to Operating Manual or Users Guide for a
description of the air conditioner operation.
Ceiling
Template
Filter
Grill