AudioCodes Mediant 2600 Panduan Pengaturan Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pengontrol AudioCodes Mediant 2600. AudioCodes Mediant 2600 8 halaman. Session border controller

Physical Description of Front Panel
1
2
[The number and type of port interfaces depends on the ordered hardware configuration.]
1
Fan Tray Module #2 with a schematic displayed on its front panel showing the chassis'
slot numbers.
2
Power Supply module #2.
3
Power Supply module #1.
4
(Slots 1-2) Covered with blank AMC modules for unused AMC slots. The slots can house
an optional, customer-ordered Media Processing Module (MPM), providing additional
digital signaling resources (DSP) for transcoding sessions.
5
(Slots 3-4) Covered with blank AMC modules for unused AMC slots.
Note:
If you purchased this device in an initial release, Slots 3-4 may be occupied by the
E-SBC CPU AMC module (instead of Slots 5-6).
If this slot is occupied by the E-SBC CPU AMC module and you have subsequently
purchased an MPM, you must re-locate the E-SBC module to Slots 5-6 instead.
6
(Slots 5-6) E-SBC CPU AMC module (hereafter referred to as E-SBC), providing CPU, serial
interface, and Ethernet interface functionalities.
Eight 1000Base-T GE (Gigabit Ethernet) LAN ports. The LAN ports can operate in
pairs, where one port is active and the other standby, providing 1+1 LAN
redundancy. The ports support half-and full-duplex modes, auto-negotiation,
straight-through or crossover cable detection.
RS-232 port (IOIO) for serial communication.
Reset pinhole button (//). To reset the device, press the button for at least 1
second (no longer than 10 seconds). To reset to factory defaults, press the
button for at least 11 seconds (no longer than 20 seconds).
Note: If you purchased this device in an initial release, the E-SBC module may be
occupied in Slots 3-4 (instead of Slots 5-6).
7
(Slots 7-8) Covered with blank covers for unused AMC slots.
Note: These slots are currently reserved for future use.
3
4
2 |
P a g e
5
6
7