AudioControl LC6i Manual - Halaman 12

Jelajahi secara online atau unduh pdf Manual untuk Konverter Media AudioControl LC6i. AudioControl LC6i 16 halaman. Six channel line output converter

Dash Bracket Installation

The dash control mounts with two screws, which attach

to the underside of the dashboard. Slide under the

dash and place the dash control in its mount-

ing position, mark the two mounting holes,

drill pilot holes, and secure with two

screws.

Custom Installation

For that custom, ﬁnished look,

the dash control can be ﬂush

mounted directly on the dash-

board (or anywhere else). We have

provided an extra label to help make this happen. Referencing Figure 8,

disassemble the dash control from the mounting bracket. Start by push-

ing the LED from its holder followed by removing the circuit board and

rotary control from the bracket. Drill a 9/32 hole in the dashboard for

the control along with a 1/8 hole for the lock tab and a 13/64 hole for the

LED holder. Reassemble the dash control components on the dashboard

and apply the new label over the openings

Dual-Color Dash Control LED

The LED on your dash control is rainforest green and should brighten

or dim when you turn the knob. Should you wish to change the color to

amber, remove the plug connected to the LED and turn it 180 degrees

and plug it back in.

Troubleshooting

It is important to remember when installing your LC6i that the engi-

neers who work for the car manufacturers don't spend too much time

thinking about interfacing after market products. Therefore you will

most likely have to "modify" your traditional wiring and installation

techniques when working with these types of systems. Many times tradi-

tional 12 volt "turn-on" wires or pre-amp audio signals that you are used

to with aftermarket systems don't exist on these newer vehicles.

No Power: If the Power LED on your LC6i will not turn on, check to

make sure that the power wire and remote turn-on wires are connected or

a fuse has not blown, and that your factory headunit is on!

LC6i Turns Off Intermittently: If you are using the GTO signal sens-

ing to turn on your LC6i yet your system is turning off, this may be due

to a cellular phone interface or navigation system built in to your factory

installed source unit. These are known to route the audio signal away

from your source unit's outputs. In these situations it is recommended

that you connect a 12-volt trigger wire from the Remote In on the LC6i.

Figure 8: Dash Control Assembly

page 12