Duplo DBM-120 Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Mesin Lipat Duplo DBM-120. Duplo DBM-120 12 halaman. Connecting kit
model: dc-6000s;dc-8000s 2;
dc-10000s
Juga untuk Duplo DBM-120: Panduan Instalasi (13 halaman)
Halaman Cetak
2. INSTALLATION PROCEDURE
1
Release the locks securing the bottom
plate of this unit and movable unit together
(2 each at the front and back).
Loosen the two screws of the fixing plate, and move
the fixing plate down and secure it.
NOTE
: Be sure to complete above work before
turning on the power, or the unit may
damage.
2
Temporarily secure the connecting plate
provided to the DBM-120 cabinet.
<< Parts to be used >>
Connecting plate !8 ............................................ 1
Screw (MSKW5 × 10) !9 ................................... 2
3
Temporarily secure the connecting plate
to the DSF-2000.
<< Parts to be used >>
Screw (MSKW5 × 10) !9 ................................... 2
4
Tighten the screws temporarily secured in step 2, and secure the connecting plate.
5
Check that the distance between the
paper in-feed slot of this unit and the
paper ejection guide of the DSF-2000 is 3
to 7 mm (0.12" to 0.28").
NOTE
: As the above range will not be satisfied if
the ground is not flat, check that the
ground is flat.
4
2-2. Connecting the DSF-2000
Movable unit
DBM-120 Sheet by Sheet
DBM-120 cabinet
Connecting plate
Connecting
plate
Screws
DBM-120 Sheet by Sheet
Guide
3 to 7 mm (0.12" to 0.28")
Fixing plate
Screws
DSF-2000
Paper ejection guide of
DSF-2000