AudioEngine S6 Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Subwoofer AudioEngine S6. AudioEngine S6 17 halaman. Wireless subwoofer
Juga untuk AudioEngine S6: Pengaturan (2 halaman)

Halaman Cetak

Rear panel controls

Volume

The volume control is for matching the subwoofer volume to the

level of your speakers. The best advice we can give on volume

levels is to adjust for the strongest bass without being "boomy''.

Note that the S6 volume controls the S6 subwoofer level only and

does not control the input volume. In other words the overall

system volume is controlled from your music source.

Low-pass crossover

The crossover control is used to set the subwoofer high frequency

cutoff point, which is the point at which the subwoofer transitions

to your speakers. For example, if the crossover control is set to

the SO Hz mark then the sub will play all frequencies up to 50Hz.

All frequencies from SO Hz and higher will then be played by the

speakers. Fine-tune the crossover setting by ear for the smooth-

est blend with your main speakers. There really are no right or

wrong setting so don't hesitate to experiment to find the sound

that works for your setup.

Phase switch

Phase is the degree to which the subwoofer and other speakers

are moving at the same time. Once you have chosen a location

for your S6, try moving the phase switch while you listen for the

most bass. Sometimes no difference will be heard, which is OK as

there's no correct phase setting and it is not uncommon for the

subwoofer to sound similar at each setting depending on your

room and sub location.