AudioEngine S8 Setup Manual - Halaman 5

Jelajahi secara online atau unduh pdf Setup Manual untuk Subwoofer AudioEngine S8. AudioEngine S8 10 halaman. Premium powered subwoofer
Juga untuk AudioEngine S8: Spesifikasi (2 halaman), Setup Manual (13 halaman)

Halaman Cetak

1. Setup Diagrams

3 Output

The Output connectors provide a full-range line-level output to speakers

or another subwoofer. This Output is used whenever a signal is connected

to one of the 2 subwoofer inputs.

Note: The volume level of this Output connection is controlled by the audio

input source, not the volume control on the subwoofer.

4 Phase

The Phase control is used to blend the sound of the subwoofer with the

other speakers in your system. Phase is the degree to which the

subwoofer speaker and other speakers are moving in and out at the same

time. Once you have chosen a location for your subwoofer, try turning

the Phase control in small amounts while you listen for the most bass

from your favorite listening position. Sometimes no di erence will be

heard, which is OK. There is no correct Phase setting and it is not uncom-

mon for the subwoofer to sound similar at every setting, depending on

your room and location of the subwoofer. If you don't hear a di erence

go ahead and set the Phase knob at the 0 position.

5 Crossover

The Crossover control is used to set the subwoofer high frequency cuto

point, which is the point at which the subwoofer transitions to your other

speakers. For example, if the Crossover control is set to the 50Hz mark

then the sub will play all frequencies up to 50Hz. All frequencies from

50Hz and higher will then be played by the other speakers. Fine-tune the

Crossover setting by ear for the smoothest blend with your main speak-

ers. The best setting of the Crossover control will depend on speaker

placement, room characteristics, and personal preference. As with the

Phase control, sometimes little or no di erence will be heard, which is OK.

Note: For surround sound setup refer to the manual for your receiver or

processor for correct Crossover settings for your system.

audioengine S8 setup guide

The Crossover control is not active when using the LFE input jack.

6 Volume

The Volume control is for matching the subwoofer speaker volume to the

level of your speakers. Keep the volume low when rst setting up your

system and then adjust to your preferred level using di erent music

and/or video sources. The best advice we can give on matching the

volume is to adjust for the strongest bass without being "boomy".

Note: The subwoofer Volume controls the AS8 subwoofer level and does not

control the subwoofer output audio level or the input level volume. The

overall system volume (subwoofer + speakers) should be controlled

directly from the audio source (TV, receiver, iPod, etc.).

7 Power On/Standby Indicator

This indicator LED will be GREEN when a input signal is present (music

playing) and RED when no signal is present (power-saving standby

mode). The AS8 subwoofer will automatically enter Standby mode after

15 minutes when no signal is detected.

8 Aux AC Outlet

9 AC Select

10 Power Switch

11 Fuse Holder

12 Power Inlet

audioengine S8 setup guide

OUTPUT

INPUTS

AUX OUTLET

Unswitched

110–120VAC 60Hz 1A

220–240VAC 50Hz 0.5A

120W MAX

LFE IN

AS8

AC SELECT

FOR 110–120V: T3.15AL

FOR 220–240V: T2AL

Replace with

~AC

110–120V 2.5A

same rating

220–240V 1.6A 60Hz/50Hz

and type