Danguard HS-400 Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan Danguard HS-400. Danguard HS-400 17 halaman.

Halaman Cetak

6. Operating with Android devices

Setting the Push Notification

Go to the Main Menu -> System -> Network

-> Push notification. in the menu item „Enab-

le / Disable", you can set the push notification

on or off. By „minimum time interval", the time

delay of a push notification can be set.

Note:

Only if the motion detection and/or heat

detection in the menu item „Recording"

is enabled, a push notice may be served.

Click at the Android app to „push notification settings" to register an account. When motion is

detected by the camera, it sends a push notification to your phone.

Important notes:

1. Only when the receiver in the real-time state, to view the image.

2. If the Device ID was unable to get to the monitor, indicates that monitor did not normally

connect outer net, need to check your network.

3. If everything is normal, but still not in the mobile phone client to view images, please close the

client software running always in the background, please try it again.

4. The network adapter does not support hot-swappable, before open the monitor, The network

is connected with the monitor.

ENGLISH

7. Operating with iOS devices

Connect to the network

Insert the receiver in the pedestal, and connect

with the base power. Then connect the outer

net. Turn on the receiver.

After successful connection, go to the Main

Menu -> Network -> Network Information. In

the monitor display the following window will

be displayed.

Note:

If you want to stream the videos over the

phone network on your smartphone, you

must enable the UPnP function on your

Internet router.

Warning: uPnP is not supported by any

Internet router. Alternatively, you enter

the port that is displayed on the display

manually.

Download & Operation the App for Android devices

Check the App Store with your mobile device (eg smartphone). Search for the application

„GoCam4CH" and download it. Install the software.

Note:

The network features with iOS devices is

only in available at the IP version of the

camera system.

The monitor does not support Plug and

Play. First, plug the network adapter and the

LAN cable before you turn on the monitor.

Networ k Informatio n

Golbal IP

Loca l IP

Port

5003

Device ID

Networ k ready!

GoCam4CH

ENGLISH