3Ware RDC-TRAY - Hard Drive hot-plug Tray Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kandang 3Ware RDC-TRAY - Hard Drive hot-plug Tray. 3Ware RDC-TRAY - Hard Drive hot-plug Tray 4 halaman. Raid drive cage

Halaman Cetak

2. Connect the cables as shown in figure 2. When connecting cables to

the IDE bus make sure the numerical pins are lined up with the

connector, else you may damage the hard disk drive.

Installing a hard drive in the disk tray

1. Remove an empty disk tray.

2. Unpack the hard drive. Set the HDD to "Master". Refer to the manufacturer's

documentation for the location of this jumper .

CAUTION: Static electrical discharge (ESD) can damage your drive or other

components. To avoid ESD, ground yourself by touching any metal on the

subsystem chassis.

3. Connect the power cable to the power connector on the hard drive.

4. Connect the 40-pin ATA cable to the IDE connector on the hard drive.

Align the colored edge of the cable with pin 1 of the connector.

720-0091-00 B

Downloaded from

www.Manualslib.com

Figure 2

QUICK START GUIDE, 3W-RDC-400 Rev March 2003

manuals search engine

Page 2 of 4