Conquip Block Grab 1000 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Pengangkatan Conquip Block Grab 1000. Conquip Block Grab 1000 8 halaman.

Halaman Cetak
Original Working Instructions

Usage Instructions

Important Usage Notes
•
This type of lifting equipment relies upon a 'crushing' force to grip the load
prior to and during the lift. There will always be the possibility that the load
(especially of soft materials) may break up and become unstable during
the lift. You should therefore inspect each load prior to lifting, to ensure its
suitability.
•
Do not allow hands or feet to come between, or below the grab and the load.
•
Do not attempt to adjust or manhandle a load whilst it is in a raised position.
•
The grab arms should not be in contact with the ground. However, when
lifting blocks, the grab arm should be no higher than 1/3 up the block.
•
Always try to lift the blocks end on rather than the sides. The loads length
must not be greater than the grab arms.
•
Do not drag the load; this equipment is for lifting the load clear off the
ground.
Using with Lifting Apparatus
1. Attach the lifting apparatus' hook to the Block Grab's lifting point. Always
ensure that the hook's gate is correctly closed.
2. Place the Block Grab on the ground making sure that its jaws are fully open.
3. Position the height of the contact wheels so that the distance from the grab
jaws to the wheels is equal to the load's height.
4. The position of the wheels is adjusted by pulling out the pins to unlock, move
the wheels up or down the arm height locator as required, then reinserting
the pins to lock.
5. This adjustment must be carried out to equal setting on both sets of wheels.
The grab is now ready to use.
6. Secure the pack to be lifted with banding. If not banded, when lifting stacked
loads such as building blocks, the blocks may separate during the lift.
7. Raise the grab and position over the load, checking that it is centrally aligned
before lowering.
8. Lower the grab until the automatic locking mechanism closes onto the load.
User Guide - Block Grab
9. Raise the load just above the ground and check that the load is correctly
balanced and secure.
10. Whilst the load is being held off the ground, fix a Safety Restraint Net. Pull
the net under the loaded Block Grab, lift up around the outside of the Block
Grab and secure the loops on the net to the safety net hooks. The net can
be adjusted by pulling up any slack on to the hooks. Only use a tested and
certified net, as supplied by Conquip Engineering Group.
11. Once the net is secured and the load is safe, proceed to move the load to its
required position.
12. Move slowly and carefully; do not jolt the load.
13. When in position, lower the load until in contact with the ground. The grab
jaws will automatically release and allow you to raise the Block Grab clear of
the load.
14. You can now proceed to the next load.
15. An unloaded grab will alter between grip and release each time it receives
a jolt. This may cause the jaws to be out of sync when you next attempt to
'grab a load'. If this is the case, lower the emptyl Block Grab to the ground to
alter to the release position before reloading.
Product Information
Specification
Item
Safety Restaint Net
Depth
Width
Length
Twine
1600mm
1500mm
1500mm
5mm
Product Code
NE100
Mesh
Weight
Compatible with
45mm
5kg
CA105
7