AUDIOLINE OSLO 501 Panduan Petunjuk Pengoperasian - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Telepon AUDIOLINE OSLO 501. AUDIOLINE OSLO 501 16 halaman. Additional dect gap handset

Halaman Cetak

2.5

Charging the batteries

When preparing to use the handset for the first time, place it in the base sta-

tion (display facing upwards) for at least 14 hours. The charging control

lamp on the base station lights up. The handset warms up during the char-

ging process. This is normal and does not represent a risk. Do not charge

the handset with charging units from other manufacturers. Failure to charge

the batteries properly can lead to telephone malfunction.

The current battery charge status is indicated in the display:

Full

2.6

Registering Oslo 501 handsets

3 sec

After pressing the Paging button, the handset registration process

must be completed within the following 90 seconds:

, y or z,

y or z,

ë,

If the handset is already connected to a base station, the corres-

ponding number flashes.

A search is then made for the base station.

When the base station is found, proceed as follows:

ë,

The handset is then registered.

The handset is assigned an internal call number. The handset al-

ready registered has the internal call number 1. The second

handset registered is assigned the internal call number 2. The in-

ternal call number appears in the right of the display when in

Standby mode.

2.7

Registering a handset on a DECT/GAP base station from

another manufacturer

Preparing the base station

Follow the instructions in the operating manual for the base station to which

you want to register your handset.

Proceed as described above but use the PIN code of the base station to

which you want to register your handset.

− Starting Up −

Half empty

Initiate the registration facility by pressing

the Paging button on the base station

Open the Register

Select the Reg Base function and confirm

Enter the number of the base station (1 to 4)

and confirm the input

Enter the PIN (default setting: 0000) and

confirm the input

Low

Empty