Danita 310M Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio Danita 310M. Danita 310M 10 halaman. Mobile cb radio

this channel by pressing PTT key. If there is no transmission or

detected signal on that channel within 5 seconds, radio will start

scanning again. To exit the SCAN function, press the SC Key or the

PTT key.

Priority Channel 9 / 19

- It the contains the priority channels 9 and 19. Priority channel 9

is selected by pressing the key (7) [ CH9/19 ] once. To set priority

channel 19, press the key (7) [ CH9/19 ] twice.

To transmit, press and hold the key(A) [ PTT ] at the microphone

and the TX icon will appear on the LCD.

For best quality, please speak normally at a distance of 2 - 4

inches. Speaking too loudly will cause distortions and make the

signal difﬁcult to understand.

On completion of the transmission release the PTT key and the

radio will revert to receiving mode.

10.

The radio is equipped with a 3.5 mm jack socket (D) at the rear

panel to connect an external.speaker of 4 - 8 Ohm impedance.

At 4 Ohm the speaker load can be 4 watts. When the external

speaker is connected, the internal speaker will be switched off.