Caslon Maxit 927 Panduan Pengoperasian dan Pemeliharaan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Laminator Caslon Maxit 927. Caslon Maxit 927 12 halaman.
Juga untuk Caslon Maxit 927: Panduan Pengoperasian dan Pemeliharaan (13 halaman)

Halaman Cetak

Issue: Coating is too thick or too thin

Cause: Position of wiper blade

Solution: Reset the blade using the instructions on Page 7of this operating guide.

Issue: Getting drops of adhesive on the leading edge of the paper.

Cause: Adhesive is building up on the leading edge of the stripper fingers after running the

motor for a while.

Solution: Turn off the motor for a minute and the drops should melt away. Also space the

fingers so there is the minimum amount needed under the paper. Reset the blade to produce a

thinner coating.

Page 11