Belcat ELAN-4TN Panduan Pengguna
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Belcat ELAN-4TN. Belcat ELAN-4TN 2 halaman. 4band eq with fnd tuner
Halaman CetakELAN-4TN PREAMP USER'S MANUAL
4Band EQ with FND Tuner
4
5
VOL.
L.B
8
9
1. Tuner LED Display
6. Treble
2. Tuner FND Display
7. Presence
3. Tuner Button
8. Volume Knob
4. Bass
9. Low Batt. (Low Battery LED Light)
5. Middle
10. Note Button
Tuner Operation
Tuner LED Display
Tuner FND Display
Tuner LED Display
: Tuning Guide LED for Sharp tune
: Tuning Guide LED for right tune
: Tuning Guide LED for flat tune
Tuner Display
The tuner will work with or without a cable plugged into the output jack.
Pushing the tuner button turns ON the tuner. When the tuner is active
the output signal is muted. No sound will go to the amplifier or mixer
when the tuner is active.
Pushing the tuner button again turns the tuner OFF and the output
signal will be active and sound will go to the amplifier.
If the tuner is ON and the tuner button is not pushed within 2 minutes
the tuner will turn OFF automatically and sound returned to the output.
The tuner Note Readout FND Display shows the nearest note of one
plucked string's sound. The Note Read Display read out shows twelve
note possibilities in half steps in "sharps" (for example: A; A#; B; C; C#;
D; D# and so on). For "flat" notes, for example: Bb (B flat) use A#. For
Eb (E flat) use D#.
6
7
10
1
2
3
1
3
Functions
3.Tuner Button
(for
Power on/off Button)
The tuner will work with or without a cable plugged into the output jack.
4. Bass
(for bass tones)
EQ TONE CONTROL
5. Middle
EQ TONE CONTROL
6. Treble
(for high tones)
EQ TONE CONTROL
7. Presence
EQ TONE CONTROL (for very high tones)
The BASS, MIDDLE, TREBLE, and PRESENCE controls are a 4-band equalizer
for controlling tone . The BASS, TREBLE and PRESENCE tone controls are
normal boost / cut shelving controls . The MIDDLE (midrange) tone control is
a normal boost / cut tone filter. The center detent on these tone controls yields
a flat tone response. "+12" boosts the tone; "-12" cuts the tone.
8. Volume Knob
The VOLUME controls the output volume. Turned fully counter-clockwise it is
completely OFF. Turned fully clockwise it is LOUD!
9. Low Batt. (Low Battery LED Light)
The LED will light when the battery has lost power. Replace the
battery when this light is on.
This LED light will flash when a cable is connected to the output
jack of the pickup system. This shows the battery is good.
10. Note Button
Battery
A 9-volt battery powers the ELAN-4TN preamp. Before connecting the
instrument to an amplifier or mixer please check that a fully charged 9-volt
battery is connected.
Specification
Features : 4Band EQ with FND Tuner
Input Impedance : 2.2MΩ
Frequency Response : 20Hz~20KHz
Control Range :
Bass
:【 ±12dB at 80Hz】
Middle
:【±12dB at 800Hz】
Treble
:【±12dB at 3KHz】
Presence :【±12dB at 15KHz】
Tuner Function：
Auto Chromatic Turning
Current Drop : 12mA
Power Supply : 9V Alkaline Battery
Low Battery Check LED
Pick-up : Piezo ceramic pick-up
Output Jack : 6.35mm (1/4")
Dimension : W 56mm X H 74 mm
(2.2" X 2.9")
Caution
- The jack should be pluged for proper Preamp working.
(TUNER will works regardless pluging jack)
- There is no output sound, please check if tuner or mute is turned on.
- When LCD screen is dim or no display, please check battery life.
- To prevent battery loss, please unplug jack when preamp is not in use.
- Do not disassemble for repair.
Return to your dealer for service or repair.
- Do not use too much force when operating the control.
(for middle tones)
2
4