Danner PONDMASTER HAMPTON CPF2000U Petunjuk Perawatan dan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Perawatan dan Pengoperasian untuk Sistem Penyaringan Air Danner PONDMASTER HAMPTON CPF2000U. Danner PONDMASTER HAMPTON CPF2000U 11 halaman. Pressurized filter system

Halaman Cetak

FILTER MAINTENANCE

The debris filter pad is first to receive the water that is pumped into the filter. When the debris filter begins to clog it can be

removed and rinsed or replaced completely. If you choose to rinse the debris filter, rinse with water taken from the pond instead

of chlorinated tap water. Doing this will avoid killing off the useful bacteria colonies that grow on the filter pads.

Conditions vary, but generally the Biomatrix Ball Media will begin to grow helpful bacteria in a few weeks. Once established, these

should not be disrupted during the warm weather season.

QUICK DISCONNECT / FLOW CONTROL VALVE INSTRUCTIONS

The intake and outlet are mounted to a

removable Quick Disconnect / Flow Control

valve.

The Blue Lever will adjust flow rate as well as

shut off the hoses allowing you to leave them

attached to the valve assembly at the pond

while servicing the filter case.

1) Turn off pump.

2) Pull Lever forward. This will close off flow in

both hoses inside the valve.

3) Pivot the Lever to the right - this unlocks

the Quick Disconnect Valve.

4) Pull Valve assembly straight upwards.

PULL LEVER

FORWARD

IMPORTANT!

CPF2000/PF1900 series

includes pressure release knobs

on both sides of the cover. Once

the corner latches are in the

open position, rotate both of

the knobs counter clockwise to

break the seal and lift the cover.

IMPORTANT! ALL MODELS:

WINTERIZATION

These filters are intended for use in non-freezing environments. If used in areas with cold winters, they must be

removed from service, dried and stored before the freezing weather occurs. Failure to do so will void the warranty.

TOP VIEW OF VALVE ASSEMBLY

BLUE LEVER UP:

Maximum ow.

ILLUSTRATION SHOWN WITHOUT HOSES FOR DEMONSTRATION

1) Always keep connection surfaces of valve assembly, cover and filter case clean

of any dirt, sand or debris before reassembling.

2) During reassembly press Quick Disconnect / Flow Control Valve completely down into

filter cover before pushing lever back to left and up into maximum flow position.

MOVE BLUE LEVER DOWN:

Reduced ow down to no

ow/ Valve closed.

PIVOT LEVER

TO THE RIGHT

Always keep Cover O-Ring and contact surfaces of cover and filter

case clean of any dirt, sand or debris before reassembling.

For Models CPF 250, 500, 1000

PF 225, 450, 900

BLUE LEVER DOWN & PIVOT

TO THE RIGHT: Valve closed

and unlocked for removal.

LIFT

VALVE

ASSEMBLY

REMOVE VALVE WITH

HOSES ATTACHED