DanPumps S-WN4 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pompa Air DanPumps S-WN4. DanPumps S-WN4 9 halaman.

2. Pump Labels

Sondex wet-end label

Example of Motor label

Technical informations subject to change without notice.

This installation and service manual are valid to the pump type S-WN series.

The series are manufactured in S-WN1, S-WN2, S-WN3 and S-W4.

The S-WN pumps are single stage, and non-self-priming pumps.

The pump is built as end-suction pump, and driven with a standard norm motor.

The pump is designed for pumping clean water, wastewater and waste water with contaminants.

Impeller model has different selections.

The S-WN can be delivered with other motor brand after choice.

Atex motor is an option

WARNING

The pumps must never be used in flammable or explosive media. If there are local restrictions concerning fire

risks they must be obeyed at all time. The pumps meet EU's machine directive, see declaration of conformity

at the back of this manual. DanPumps guarantees that the pumps' airborne noise level does not exceed the

noise level of 74 dbA (at normal operation).

WARNING

If people can get physical contact with the pump or the fluid that is being pumped at e.g. open excavations,

building sites or the like, a fault circuit-breaker (HFI or HPFI) must be mounted in the electrical installation.

If the pump is used in oceans, lakes etc. there must be a minimum safety distance of 20 meters between the

pump and any persons in the water. The national country and local standards has at all time to be observed

NOTE that in swimming pools there are special safety restrictions.