Audioplex INW-2 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Audioplex INW-2. Audioplex INW-2 8 halaman. In-wall stereo switcher

Power:

Load:

Size:

Connections:

*For amplifiers requiring a load of 8 Ohms or higher you must adjust tap settings to X16 when using more than 2

sets of 4 or 6 Ohm speakers.

The INW-4 switches up to 4 pairs of 4, 8 Ohm or higher impedance speakers in any

combination, while maintaining a safe load to the amplifier. The load protection is achieved by use of an

impedance matching transformer, which offers several significant advantages. First, there is little or no heat

developed whether one or all the speakers are operating simultaneously, so no fire hazard exists with the in-wall

switcher. Second, all switching can be contained in a single in-wall junction box without modification.

The INW-4 is supplied with two impedance matching jumpers that are normally connected to the X4 position,

which multiplies the speaker impedance to 4 times the nominal value. Thus if 4 pairs of 4 Ohm speakers are

switched on at the same time, the parallel impedance load would be 1.0 Ohms. The transformer setting multiplies

the impedance by 4, so the total load to the amplifier appears as 4 Ohms. The jumper settings can be adjusted to

accommodate different situations.

Wires should be stripped about 1/4", inserted in the appropriate connector opening, and the screw tightened.

Check to be sure that no stray strands stick out to cause short circuits!

Your AUDIOPLEX TECHNOLOGY INW-4 Series Speaker Selector is covered by a LIFETIME

warranty against any defects in workmanship and materials. Any defects will be remedied without

charge for labor or parts.

Damage incurred by shipping or accident is not considered to be a defect, and not covered by this

warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused by abuse

or by modification or service by any unauthorized person or agency.

The unit must be properly installed and operated according to instructions for the warranty to apply.

Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The unit must be returned

expenses prepaid, with written authorization from the company. The product must be shipped with the

proof of purchase and in the original carton and packing material to avoid damage. This warranty gives

you specific legal rights. You may have other rights which vary from state to state.

INSTALLATION MANUAL

TECHNOLOGY

INW-4

IN-WALL STEREO SWITCHER

Transformers rated at 72 Watts RMS continuous (216 Watts audio) 35Hz-20kHz

Match up to 4 pairs of 4 or 8 Ohm speakers with all on simultaneously.*

INW-4 fits most single in-wall junction boxes.

Screw type connectors.

IMPORTANT

INSTALLATION

WARRANTY

2000 - 6/20/00