Beldray EH0089 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Perapian Dalam Ruangan Beldray EH0089. Beldray EH0089 15 halaman. Conception wall fire

Instructions for Use

Before First Use

When using this Conception Wall Fire for the first time, a slight odour may be emitted. This is

normal and will subside after a few uses.

Place the Conception Wall Fire on a flat, stable, heat-resistant surface at least 1 metre away from

furniture, curtains or any other flammable materials.

If placing the Conception Wall Fire in an alcove, make sure that there is at least 150 mm of space

on all sides, to ensure good air circulation.

The Conception Wall Fire must not be located over a mains power socket. The mains power

socket must always be accessible in order to disconnect the Conception Wall Fire from the

mains power supply for cleaning, maintenance or when replacing a bulb.

Wall Mounting the Conception Wall Fire

Installation of the Conception Wall Fire should be carried out by two people in order to avoid

injury, damage to the property or the fireplace.

STEP 1: Ensure that the Conception Wall Fire is unplugged from the mains power supply.

STEP 2: Open the fixing pack and place all of the contents into a container. This will reduce the

risk of losing any small pieces.

STEP 3: At the rear of the Conception Wall Fire at each side, there is a bracket (shown below).

These fire brackets engage behind the wall mounted brackets to provide a secure fixing method

that cannot be seen in normal use.

Hold the fireplace to the wall that it will be fixed to and using a pencil, mark the height of the

brackets at each side of the fire.

30 mm

STEP 4: The wall bracket needs to be mounted approximately 30 mm inwards from the outer

edge of the fire surround to match the position of the fire brackets. Hold the wall brackets in

place and carefully mark the positions of the screw holes onto the wall.

EH0089 Conception Wall Fire