Audioplex VC200 IRTarget Panduan Instalasi

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penerima Audioplex VC200 IRTarget. Audioplex VC200 IRTarget 4 halaman. Remote receiver and processor of infrared signals

Halaman Cetak

INSTALL ATION MANUAL

IRTarget

Connector:

Mounting:

Remotes:

Range:

Acceptance angle:

Wire:

Power:

VOLUME CONTROL

Attenuator type:

Connector:

Power rating:

Frequency response: +0, -1 dB worst case(-6 dB tap), +0, -0.2 dB all other taps, 35 Hz-20 KHz,

Transformers:

Attenuation:

Your IRTarget is designed to act as a remote receiver and processor of infrared signals.

This sensor will receive signals from remote controllers and send these signals to a remote

repeater. This allows remote operation of any unit from the room where the VC IRTarget is

located. The addition of a 25 Watt volume control allows you the convenience of complete control

from a single plate.

CAUTION: Take care to make sure that the VC IRTarget installation is NOT IN THE LINE

OF SIGHT OR REFLECTION with the blinker(TM) repeater. If radiation from the repeater is

picked up by this sensor, a feedback situation is created which will result in instability and

unreliable operation. Undesirable reflection can occur off of light colored walls, windows, mirrors,

and even shiny wood finishes!

Any standard type of wire can be used. Shielded or coaxial cable is not usually required

unless the wire passes through some unusually high electrical interference regions.

Prepare the wire leads to and from the VC IRTarget by stripping about 1/4" of insulation

from each of the ends. Twist strands tightly together so that none stick out to cause a possible

short circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in order.

TECHNOLOGY

VC75 IRTarget

SPECIFICATIONS:

Screw-type, 3 wire, non-removable.

Fits into most standard single electrical junction boxes.

Will handle almost all standard remote controllers (Note: does NOT work

with B & O equipment, which requires a proprietary confirmation talk-back

function).

110 feet indoors, 15 to 20 feet in direct sunlight.

+ or - 55 degrees off center.

Uses conventional unshielded "zip" or telephone wire.

12 VDC @ 500 mA power supply (not included).

Tapped auto transformer.

screw-tight type, removable

25 Watts RMS continuous, 35 Hz-20 KHz, 75 Watts audio.

measured at full power, 8 Ohm load. Most controls better these

specifications.

Tri-filar wound for flat response and minimum phase shift, grain orientated

high silicon steel laminations.

-34 dB in 12 steps, 8 steps @ -3 dB each, 1 step @ 4 dB, 1 step @ -6 dB,

last step OFF .

INSTALLATION:

(Patent Pending)

1999 - 4/22/99