Consort PRX075 Manual Instalasi dan Kontrol - Halaman 4
Jelajahi secara online atau unduh pdf Manual Instalasi dan Kontrol untuk Pemanas Consort PRX075. Consort PRX075 4 halaman. Wireless controlled panel convector heaters
Halaman Cetak
4
Controls
When the appliance is connected to
the mains supply and the wall socket is
switched 'ON' the mains neon
indicator will light, showing that the
power is available to the unit.
Operation
This heater can only be used when
connected to a CRX2 wireless
programmable controller. Each CRX2 can
control any number of heaters.
Please refer to the CRX2 installation and
control guide for full operational details.
66000728 Iss 02
Mounting
This unit is for wall mounting only; the wall
bracket supplied must be used. Please refer to
illustrations provided on page 3 of this booklet.
Remove wall bracket from the heater, with
•
the chains attached, by removing the 2
securing screws from the top of the rear
panel.
Fix wall bracket to wall using 4 screw holes
•
Present heater to bracket
•
Locate heater onto bottom lugs via 2 sets of
•
relevant slots in rear panel. Hinge heater
upwards and replace screws with link plates
of chain attached, then move heater to
upright position. The link plates should slide
under the slotted bracket lip.
Tighten both retaining screws.
•
The heater must not be located immediately
below a fixed socket outlet.
CRX2
wireless controller