Audioplex HD-100 Panduan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Audioplex HD-100. Audioplex HD-100 17 halaman. Reference amplifier

Front Panel

1. LEVEL CONTROL

This determines the level of the input signal for each channel. In stereo mode the knobs will determine the

signal level independently for each channel. In the bridge mono mode only the channel 1 level control is used.

2. SIGNAL INDICATOR

This indicates the level of the input signal. This should be illuminated during normal operation.

3. CLIP INDICATOR

This LED warns of a problem in the system when illuminated. Reduce the LEVEL of the device which supplies

signal to the amplifier or reduce the LEVEL control(s) on the amplifier. This LED should not be illuminated

during normal operation.

4. PROTECTION INDICATOR

This LED warns of a problem in the system when illuminated. Reduce the volume and look for problems. It is

possible that the amplifier is too hot or the speaker impedance is too low. This LED should not be illuminated

during normal operation.

5. POWER INDICATOR

This LED indicates the amplifier is switched ON and receiving AC POWER when illuminated.

6. POWER SWITCH

The position of this switch determines whether the power is ON or OFF. The power-on status is confirmed by

the power indicator. Amplifiers are always the last item in a system to be turned on. It is a good idea to turn

down the level controls before applying AC mains power.

7. HANDLE

Handles are provided for moving and installing into equipment enclosures or racks.

REFERENCE AMPLIFIER

POWER

TECHNOLOGY

HD-100

OFF

HD-100