Consort EV2150 Manual - Halaman 11
Jelajahi secara online atau unduh pdf Manual untuk Catu Daya Consort EV2150. Consort EV2150 16 halaman.
Halaman CetakRunning condition
Display
600
1|2
When running an experiment, the display allows to see the actual parameters. It is divided into three
fields:
The upper left field shows :
•
◦ a blinking symbol to indicate there is a possible dangerous condition on the output sockets.
Avoid to contact the outlet sockets and cables!
◦ the selected measured parameter. Use the é ê keys to switch the parameter in this field.
The upper right field shows the other 3 parameters.
•
The bottom field shows date + time at the right and the actual method/step combination at the
•
left when such a procedure is running, no indication when running a manual procedure. The
bottom field line is also used for system messages when required.
The unit of the parameter that is being kept constant is given with blinking bold characters.
Buttons
The keys be used as follows:
é ê
Buttons for selecting another parameter in the upper left corner of the display .
•
Button to modify the parameters.
•
/
Button to stop or to pause the procedure.
•
Adjusting parameters
It is possible to modify the parameters while running. These modifications are temporarily and are not
stored in the non volatile memory. It is not possible to modify the settings of a voltage gradient step.
Press :
•
600
é ê
The display shows the preset values for V, mA and W. The timer remains counting down when a
•
timer value has been set.
Choose the limit to adjust with the button.
•
Adjust the value with the é ê buttons.
•
The display will return automatically to the normal run mode when no button is pressed for 5
•
seconds.
Rev. 1605
v
00:29:33 h
17/12/15 10:36:18
v
=ADJUST, =NEXT
85 mA
51 W
1000 mA
150 W
00:29:33 h
Manual Power Supplies
9