Audioprobe Spartan Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Perekaman Audioprobe Spartan. Audioprobe Spartan 8 halaman.

FRONT VIEW

1. LED Indicator USB Link/Stream

If SPARTAN A is connected to a computer and communicates

with the driver properly, the LED lights up as green (USB Link). The LED turns orange while

carrying out communication between SPARTAN A and a computer. Do not unplug the SPARTAN A

from the computer while the orange light is on.

2. +48V Phantom Power Switch

When this switch is on, the XLR jack features +48V phantom

power. Phantom power is used to power condenser microphones. Check your microphones speci-

cation.

3. Mic Input Gain Control Knob

Adjust Microphone preamp gain by rotating this knob.

4. Instrument Input Gain Control Knob

Adjust Instrument preamp gain by rotating this knob.

5. Direct Monitor Switch

Turn on this switch to monitor input sources on outputs. Monitor mix

is based on -3dB Pan Law.

6. Headphone Level Control Knob

By rotating this knob you can adjust HP output level .

7. Line Output Level Control Knob

By rotating this knob you can adjust Line Output level.

8. Headphones

Connect your headphones on this connectors.

9. Signal Indicators

The Signal Indicators of all channels allow you to check input and output

signal status easily. Brightness-controlled Green light turns on according to intended signal level.

Red light turns on when a signal reaches to peak level on input channels. An excess signal beyond

0dBFS is totally distorted in digital recording domain. Make sure that input level does not exceed

0dBFS in your recording software.