Danville Signal Processing DSP-8200d Panduan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Perekaman Danville Signal Processing DSP-8200d. Danville Signal Processing DSP-8200d 14 halaman. Tone suppression & noise reduction system
Halaman CetakCable Connections & Jumper Configurations
DSP Module Jumper Configuration (JH1)
Mode*
Tone Reduction
Noise Reduction
Bandpass Only
Reserved
Reserved
Ground/Ground tones - Narrow BW
Ground/Ground tones - Wide BW
Bypass
Notes:
* 300-3400 Hz Bandpass in all Modes
except Bypass
WARNING:
DO NOT USE TONE REDUCTION FOR GUARD
FREQUENCIES 121.5 MHz AND 243.0 MHz. YOU MUST USE
BANDPASS MODE ONLY FOR THESE FREQUENCIES.
RJ-45 Connector
Audio In - Pin 1 & 2 (600 Ohm Balanced)
Audio Out - Pin 3 & 6 (600 Ohm Balanced)
Ground - Pin 8
Reserved - Pins 4,5,7 (leave open)
Note: These connections are the same as
Ethernet 10BaseT; off-the-shelf
Cat 5 cables may be used.
3
Off
Off
Off
Off
On
On
On
On
Jumper
2
1
Off
Off
Off
On
On
Off
On
On
Off
Off
Off
On
On
Off
On
On
Page 8