DURASONIC DS20L Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembersih Perhiasan Ultrasonik DURASONIC DS20L. DURASONIC DS20L 17 halaman. Ultrasonic cleaners

Halaman Cetak

Cleaning Items

NOTE: To stop ultrasonics at any time, press red off button.

Step

Action

Set the TIMER for the amount of time you wish the items to be cleaned.

Place the items into a basket.

Slowly lower the basket into the tank. Do not allow items to contact the tank

bottom.

When items are clean and time is up, slowly remove them from the cleaner.

Rinse the clean items with clean water and dry them, if necessary.

Draining Your Cleaner

2L, 3L, 4L, and 6L models do not have a drain. To empty, use the side of the rim to

pour the used solution into a waste disposal unit, rinse the tank thoroughly and refill with

new solution.

Optimizing Your Cleaner

Cleaning - check the tank for contamination whenever you change solution. If

necessary, remove contaminants with a nonabrasive cloth and water.

Emptying - always unplug the cleaner before emptying the tank. Empty the solution into

a waste disposal unit.

Filling - always unplug the line cord before filling the tank. Fill the cleaner to the

operating level (one inch from the top with beaker/tray in place), using warm tap water.

Low solution level - will cause the cleaner to fail. When you remove heavy or bulky

loads from the cleaner, the solution level may drop below the operating level. If so, be

sure to replace lost solution and degas, if necessary, depending on the amount used.

Overload - do not rest any items on the tank bottom. Weight on the tank bottom

dampens sound energy and will cause damage to the transducer. Instead, use a tray

and/or beaker positioning cover to support all items. Allow at least one inch between the

tank bottom and the beaker or receptacle for adequate cavitation.

Covers - allow the cleaner to heat up faster, to a higher temperature, and avoid

excessive liquid evaporation.

Heater - the heater may cause some discoloration of the tank wall. This is normal and

will not affect the performance of the unit.

Warning

Do not immerse the cleaner in water.

Unplug the cleaner from the power source.