Contacta STS-K071 Instalasi & Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Instalasi & Panduan Pengguna untuk Sistem interkom Contacta STS-K071. Contacta STS-K071 20 halaman. Window intercom system - speaker and microphone pod
Juga untuk Contacta STS-K071: Instalasi & Panduan Pengguna (16 halaman)
Halaman Cetak
Speaker Pod and Screen Mounted Microphone - STS-K072
1. Position the screen mounted microphone stem's on the customer side of
the counter top.
2. Mark the 2 fixing points and 1 cable route ready for drilling (see the
diagram below).
3. Drill pilot holes for the fixings and a cable hole if neccesary.
4. Feed wiring through the cable hole back to the amplifier and fix the
microphone in place using the supplied screws.
5. Fix the microphone head to the screen using the double-sided pad
supplied.
6. Place the staff pod on the staff side of the counter top, ensuring it does
not cause an obstruction and is as close to staff as possible. It should
ideally be no more than 300mm away from a staff member.
7. Place the speaker pod on the customer side of the counter top, ensuring it
does not cause an obstruction.
8. Speaker pods and staff pods can be either free standing or fixed. Move to
step 13 if you do not wish to fix the pods to the counter.
9. Use cable management holes in the counter to run the staff pod and
speaker pod cables to the amplifier. If there are not already cable
management holes, drill suitable locations near the rear of both the staff
and customer sides of the counter.
10