Contacta STS-K015-01 Instalasi & Panduan Pengguna - Halaman 12
Jelajahi secara online atau unduh pdf Instalasi & Panduan Pengguna untuk Sistem mikrofon Contacta STS-K015-01. Contacta STS-K015-01 16 halaman. Speech transfer system
Halaman Cetak
Setup Areas
Whilst in Engineer Mode, there are 3 editable Setup Areas. You will always
enter Setup Area 1 first. The green LED will flash to indicate which Setup Area
you are in.
Setup Area 1:
Maximum Volume Adjustment
Set the maximum volume using
the below buttons.
Setup area 3:
Setup Area 3:
Hearing loop drive adjustment
Hearing Loop Drive Adjustment
Drive level increase/decrease
Drive level increase/decrease using
using the below buttons
the below buttons.
8
7
6
5
4
3
2
1
Status
Vol Out
The drive level should be adjusted so the red LED 8 is illuminated only when
there are peaks in the speech volume.
If the amplifier does not have a loop attached, you can turn off the red loop
fault LED 8 by adjusting the drive down to off.
Please note:
•
If the amplifier detects an error in its' settings memory it will restore itself
to factory default settings.
•
The amplifier will exit Engineer Mode if the "On/Off" button is pressed at
any time or if no button has been pressed for a period of 2 minutes.
Increase drive
Decrease drive
Setup Area 2:
Ducking Adjustment
Turn on/off and increase/decrease
ducking levels using the below buttons.
The drive level should be adjusted so
the red LED 8 is illuminated only when
there are peals in the speech volume
(once every few minutes max.)
If the amplifier does not have a loop
attached you can turn off the red
loop fault LED 8 by adjusting the drive
down to off
12