Contacta STS-K009 Instalasi & Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Instalasi & Panduan Pengguna untuk Sistem Konferensi Contacta STS-K009. Contacta STS-K009 16 halaman. Speech transfer system, surface mounted entry system
Halaman CetakMicrophone & Speaker Installation
1. Place the staff microphone on the staff side of
the partition, ensuring that it does not cause an
obstruction and is as close to staff as possible.
It is ideally positioned no more than 300mm
away from the staff member.
2. Use the cable management hole to run the staff
microphone cable back to the amplifier. If there
is not already a cable management hole, drill in a suitable location near
the rear of the counter.
3. Find a suitable location for surface mounted entry unit. It is ideally be
placed at head height (approximately 1.65m) from the ground to allow
most customers to easily press and speak into it.
4. Mark the four fixing points for the surface mounted entry unit and drill
the holes.
5. Secure the surface mounted entry unit to the surface using the screws
provided.
6. Run the cables from the pods through through the surface.
7. Route all the cabling neatly to the amplifier location on the staff side.
6
Fixing
points
Cable
management
hole
Staff
microphone