Audiotel International 2-197-869 Panduan Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sensor Keamanan Audiotel International 2-197-869. Audiotel International 2-197-869 16 halaman. Non-linear junction detector

Halaman Cetak

SuperBroom Plus TA – Operating Manual

It is recommended that users initially adopt the following

search strategy. As experience is gained, users can develop

their own techniques and methods.

1 Set the maximum legal transmitter power for country of

operation at the set power menu during startup (UK = EU

High).

Note For non EU countries TX power is set using the rotary power

output control (9).

2 Begin with the SuperBroom set to CLICK , COMPARE and

Power mode (these are the default settings). Select DSP

mode by pressing Listen.

3 Set the Volume control to minimum, set the Squelch control

fully anticlockwise and connect the headphones. Adjust the

volume control to suit (using the Test Target to generate a

signal if necessary). The headphones are not needed at this

stage so can be worn around the neck

4 Pass the Antenna Head over all surfaces in the search area

so that, ideally, the distance between the antenna head and

a potential concealment is minimised (for effi cient operation

the minimum distance should not be less than 6 inches).

Repeat coverage of an area after rotating the antenna head

through 90 degrees

5 If a target is detected the difference in second and third

harmonic signal strengths will be displayed on the Antenna

Head. Move the antenna until the COMPARE signal

strength reaches a maximum.

6 Search the identifi ed location for the device.

RetainingScrew

Battery Compartment Door

AUDIOTEL INTERNATIONAL Ltd – Issue 3.1 (09/2004 )

Setting Up