DURASTAR DRPDRAD09F1A17 Panduan Pemilik dan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik dan Instalasi untuk Termostat DURASTAR DRPDRAD09F1A17. DURASTAR DRPDRAD09F1A17 10 halaman. Wired thermostat

Halaman Cetak
3. Mount the back plate of the thermostat on the wall, with three M4 screws and anchors.
Back Plate
Screws M4
4. Reattach the top panel of the thermostat.
5. Mount the back plate of the thermostat on the wall, with three M4 screws and anchors.
DURASTAR.COM
8

Embedded Wire Mounting

1.
For embedded mounting, remove the
top panel of the thermostat by inserting
a screwdriver into the two slots on
the bottom.
WARNING
• The Printed Circuit Board (PCB) is mounted in the upper panel of the thermostat.
Be careful not to damage the board with the screwdriver.
2. Fasten the back plate to a switchbox
with two M4x25 screws.
OR
Fasten the back plate to a wall
with two M4 screw.
Embedded Switch Box Wiring
Wiring Hole
Slots
Back Plate
One M4 Screw
Two M4x25 Screws
Wiring through Wall
Wall hole and wiring hole
Diameter of wall hole Φ 2 cm
DURASTAR.COM
9